WHEEL HUB – Remove & Replace – 1500,4WD Front,One Side – RIGHT
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures.
Tire Rotation
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
AIR CLEANER ELEMENT – Remove & Replace
Remove and reinstall four wheels and rear brake drums to inspect brake condition. Inspect entire system for leaks. – Technician found deep groove on rotors and inside pad at 2/32. – RECOMMEND REPLACING FRONT PADS AND ROTORS
Replace front brake pad linings and rotors. Clean and lubricate brake calipers and slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle.
Patch Tire- Dismount tire and install patch and balance tire.
Paul G. gave our service a 5 star review on 7/27/2022
2007 Chevrolet Silverado CRM Mitchell1
2022-07-28T22:00:20+00:00
WHEEL HUB &/OR BEARING – Remove & Replace – Front,One Side – LEFT
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
CABIN AIR FILTER – Remove & Replace
Tire Rotation
AIR CLEANER ELEMENT – Remove & Replace
Irina K. gave our service a 5 star review on 7/14/2022
Technician installed new fuse – wipers turn on and off properly at this time – Pulled engine codes – P0406 – EGR Position sensor high – P0404 – EGR position sensor performance – P0420 Catalyst 1/1 Efficiency – Front control module messages not received – this code may have been caused by removing fuse or possible intermittent can bus communication problem
Mark I. gave our service a 5 star review on 7/13/2022
2007 Chrysler Town & Country CRM Mitchell1
2022-07-14T22:02:25+00:00