Check and inspect suspension components: ball joints, tie rods, idler arms, springs, bushings. – After test drive and inspection technician found rock rattling around in rear shield for aftermarket parts also noticed lower control arm heim joints turned to sides possibly causing contact noise – greased and straightened heim joints and removed rock from shield – test drove again and noise is gone
Jimmy R. gave our service a 5 star review on 8/24/2022
Failed VSI due to – Headlights not DOT approved – Fog lights not DOT approved – Windshield tint below AS1 line – Obstruction on headlight – remove sticky black tape
James H. gave our service a 5 star review on 4/28/2022
Failed due to : – Both rear turn signals inop – Both rear brake lights inop
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures.
– Replaced L/R turn signal bulb – STILL INOPERABLE – Checked fuses and found 2 15amp fuses blown – Replaced 2 fuses – still no rear turn signals or brake lights – Pulled codes from TIPM – B1644 – Rear left turn signal control too high – B1647 – Rear right turn signal control too high – B 1643 – Rear left turn lamp circuit too low – Cleared codes lights are now working
Jacob N. gave our service a 5 star review on 9/24/2021
STABILIZER BAR CONTROL LINK – Remove & Replace – Both Sides
Technician found no problems with CV axles or struts. -Technician found front sway bar and stabilizer links have excessive play causing banging noise when turning and driving over bumps.
WINDOW SWITCH – Remove & Replace – Master Switch
Jacob N. gave our service a 5 star review on 1/7/2021